Digital Monitoring XR5 Guide de l'utilisateur télécharger pdf (Page 16)

XR5 User’s Guide

LED Keypad User’s Guide

Yellow Trouble LED

when the system is unable to send a report to your central

station or when the phone line is in a bad condition.

Off

when the system is operating correctly.

Off when the system is operating correctly.Off

Pulse

(1 second on, 1 second off) when there is a problem with

the system. Call for service.

Green Power LED

when AC and battery power are okay.

Off

during AC trouble.

Flash

(1/2 second on, 1/2 second off) when the system’s

battery is low or missing.

Zone Alarm and Trouble LEDs

Red Zone Alarm LEDs

steady during an alarm condition.

Off

when the zone has restored to normal and a Sensor Reset

has been performed.

Yellow Zone Trouble LEDs

during a trouble condition.

Off

when the zone restores to normal.

Pulses

if the zone alarm or trouble is a Supervisory type zone.

Alert Tones

Steady Tone

indicates a trouble condition on the system or a

 re zone. Follows the operation of the bells. Pressing any key

silences a steady alert tone.

1 Short Beep

is emitted each time a key is pressed or a valid

function is entered.

4 Short Beeps

are emitted when an incorrect key or function

is entered.

Keyboard Backlighting

The keyboard on the 692F lights any time a key is pressed or the

alert buzzer sounds making it easy for a user in a darkened room

to enter their code or perform a command function.

Keypad Function Keys

SILENCE

Press the

SILENCE

key and enter the user code to silence a

system alarm and the keypad sounder. You may also use the

SILENCE

key to silence the bells during the Fire Drill function.

RESET

Press the

RESET

key and enter the user code to reset a zone

after an alarm.

This resets all zone alarm LEDs and momentarily drops power to

the panel’s zones 2 to 5 and smoke power output.

TEST

Press the

TEST

function key and enter the user code to initiate

the panel’s System Test function.

This test rings the panel bells for 2 seconds, checks the battery

charge level, and sends a system test report to the central

station on monitored systems.

CODE

To change the system user code, press

CODE

, enter the current

user code followed by 0 + 1, and then enter the new 4-digit

user code.

The user code must always be 4 digits.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Digital Monitoring XR5 Guide de l'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Détecteurs de fumée Digital Monitoring XR5